Use the Xactum Intelligent Laser Gauges as bench-top micrometers, in the Table-Gauge configuration: with no other instrument can you measure diameters so quickly, so accurately and so easily.
The XLS gauges are programmed with a dedicated software and are completed with a display unit, a remote control, fixturing to hold the part and a base-plate for bench-top use: using this “Table-Gauge” assembly you can, in a few seconds, check the diameter, roundness and the concentricity of ground or turned parts, to an accuracy that before only could be obtained in a metrology room, by using much more expensive equipment and specialized personnel.
AVANTAGES
It measures the diameter and the ovality of the part
It also measures the center position and the section concentricity
It checks the pre-set tolerances
It sends the measured data to a PC, through the RS232 or Ethernet link
VERSIONS
Single Axis Systems
TABLE-GAUGE.X40
Measuring Field: 40.5 mm Measurable Diameters: from 0.06 to 40 mm Repeatability: up to ± 0.1 µm
TABLE-GAUGE.X80
Measuring Field: 80 mm Measurable Diameters: from 0.75 to 78 mm Repeatability:up to ± 0.3 µm
TABLE-GAUGE.X150
Measuring Field: 150 mm Measurable Diameters: from 0.8 to 149 mm Repeatability: up to ± 0.4 µm
Dual Axis Systems
TABLE-GAUGE.XY13
Measuring Field: 40 mm Measurable Diameters: from 0.03 to 10 mm Repeatability: up to ± 0.03 µm
TABLE-GAUGE.XY35
Measuring Field: 80 mm Measurable Diameters: from 0.2 to 32 mm Repeatability: up to ± 0.2 µm
