Part inspection and setup on machining center
Machine tool field is in continual technologic evolution. The demand for increasingly precise parts and mass production involve the need of higher performance technologies.
Conditions:
Reaching competitivity means to have the production process under full control :
- Part co-ordinate set-up
- Part dimensional control directly on the machine
Solution:
Marposs probes offer the best solution to optimize time and quality of machining.
- Small machining centres require ultra-compact probes that can be seat in the tool holder
- Infra-red probes offer the best compromise between machining times and quality for medium machining centres.
- Wireless bore gauge for part inspection
- Big machining centres and those with 5 axes require probes with a wide transmission range, which can be achieved by using radio transmission technology.
- The best result can be obtained implementing software cycles for part set-up and part inspection.
Benefits:
- Reduced machining and control times
- Raising production efficiency
- Real time detection of the part positioning
- Reduced rejects
- Parts can be measured whilst clamped on the machine
